Clear Resin Screed Sealer

ZenRite Coat Screed Seal is an epoxy resin screed seal used for sealing ZenRite Decor Quartz Screed and ZenRite AFS Epoxy. ZenRite Coat Screed Seal is a thixotropic coating designed to be worked into the surface of open textured resin screeds in order to fill all small voids and pockets in the surface improving resistance to the industrial environment.

• Offers added chemical resistance to the screed it is applied to
• Gives improved cleanability
• Easy to apply
• Low Odor

Mixing
Transfer the contents of the hardener into the resin and mix for 1-2 minutes with a slow speed powered stirrer until an even colour and consistency is achieved. ZenRite Coat Screed Seal is highly thixotropic, careful and thorough mixing is required.

Application
ZenRite Coat Screed Seal should ideally be applied within 48 hours of the application of the screed system. Apply to the clean surface with a polypropylene squeegee. Ensure that the ZenRite Coat Screed Seal is forced into the surface of the resin screed and pull down any excess to leave a thin coating. Finally roller off to achieve, an even, film finish. ZenRite Coat Screed Seal does not tend to flow therefore it is important to ensure that the finish is to an acceptable standard whilst wet. After overnight cure apply a further coat of ZenRite Coat Screed Seal or ZenRite Coat Industrial to provide a wearing finish. Where long term, light stability is required protect with ZenRite Coat Chemical.

Delivery on standard coloured products, workwear and accessories is 2-3 days. If this delivery time cannot be fulfilled due to stock levels or if a bespoke or non-standard colour has been requested you will be notified by email with expected delivery times.